DONAT STEMSciences and MathsENFR
Biology · Simulation and virtual lab Free

Nerve impulse: threshold, action potential and refractory period

Stimulate a neurone, read the membrane potential on the trace and discover the rules that every nerve impulse obeys.

  • Best for S6 · Unit 6: Nervous coordination
  • Also useful S6 · Unit 5: General principles of reception and response (receptors produce impulses)
  • Also useful S5 · Unit 2: Transport across the cell membrane (ion channels and active transport by the Na⁺/K⁺ pump)
You will learn to
  • Describe the resting potential and the changes during an action potential.
  • Show the threshold and the all-or-nothing law with stimuli of different strengths.
  • Measure the refractory period and compare conduction in myelinated and non-myelinated axons.
You will measure
Membrane potential (mV); whether an action potential occurs; conduction speed (m/s).
Time needed
About 30–40 min
Equipment
Nothing extra. Real version: not possible in a school laboratory; use reaction-time and reflex activities.
Price
Free: no payment, no account.

Simulation

When a motorcyclist in Musanze sees a goat on the road, an impulse travels from the eye to the brain and down to the hand on the brake in a fraction of a second. Every one of those impulses is an action potential: a rapid change in the potential across the membrane of a neurone.

Change and observe

Virtual lab

Follow the steps with the simulation above (go back to the simulation ↑). Each time you tap Record, a row is added to the table and a point to the graph.

Aim

To find the threshold stimulus, to show that action potentials are all-or-nothing, to measure the refractory period and to compare the speed of conduction in different axons.

What to do

  1. Keep One stimulus. Set the stimulus to 5 mV and tap Stimulate. Record. Repeat for 10, 14, 15, 16, 20, 30 and 40 mV.
  2. Find the smallest stimulus that gives an action potential. What membrane potential does it reach?
  3. Compare the peaks for 20 mV and 40 mV stimuli. What does “all-or-nothing” mean?
  4. Choose Two stimuli of 20 mV. Record with 9, 6, 5, 4, 3 and 1.5 ms between them.
  5. Set the time between them to 3.5 ms and increase the stimulus to 30 and 40 mV. When does the second impulse come back?
  6. Change the type of axon and compare the conduction speeds.

Results

⚠️ Avoid these mistakes

  • Thinking a stronger stimulus makes a bigger impulse: above the threshold every impulse is the same size.
  • Saying the inside of a resting axon is positive: at rest it is about −70 mV, inside negative.
  • Mixing up the ions: Na⁺ moves in during depolarisation; K⁺ moves out during repolarisation.

✍️ Conclusion

Write your own conclusion first: what do your results and graph show, and which law or principle do they support?

Check your conclusion

No impulse forms until the threshold (−55 mV) is reached; above it every action potential rises to the same +40 mV (all-or-nothing). For about 2 ms after an impulse no new impulse can start, and up to about 5 ms a stronger stimulus is needed. Myelinated axons conduct impulses much faster by saltatory conduction.

Questions

What is the resting potential of a neurone and what causes it?

About −70 mV (inside negative). The sodium–potassium pump moves 3 Na⁺ out for 2 K⁺ in, and the membrane lets more K⁺ leak out than Na⁺ leaks in.

What happens during depolarisation?

Voltage-gated sodium channels open, Na⁺ ions rush into the axon and the inside becomes positive, up to about +40 mV.

What happens during repolarisation and hyperpolarisation?

Sodium channels close and potassium channels open; K⁺ ions leave, the potential falls back and briefly goes below −70 mV (hyperpolarisation) before the resting potential is restored.

What is meant by the all-or-nothing law?

A stimulus below the threshold gives no impulse; any stimulus above the threshold gives an impulse of the same size. A stronger stimulus gives more impulses per second, not bigger ones.

Why can no second impulse start 1.5 ms after the first?

The axon is in its absolute refractory period: the sodium channels are inactivated and cannot open again until the membrane is repolarised.

Why do impulses travel faster along myelinated axons?

Myelin insulates the axon, so depolarisation happens only at the nodes of Ranvier and the impulse jumps from node to node (saltatory conduction).

For teachers: expected results and how the model works

Model: resting potential −70 mV; threshold reached with a depolarisation of 15 mV (−55 mV); action potential to +40 mV, repolarisation to −80 mV, recovery about 4 ms. Absolute refractory period 2 ms after the first stimulus; relative refractory period 2–5 ms, during which the stimulus needed rises from 40 mV to 15 mV and the second peak is smaller. Speeds are typical textbook values: myelinated 10 µm about 60 m/s, non-myelinated 10 µm about 3 m/s, non-myelinated 1 µm about 1 m/s.

Quick check 3 questions · scored

Choose one answer for each question. You see at once if it is right, why, and your score at the end.

1. What is the resting potential of a typical neurone?

2. A stimulus twice the threshold strength gives…

3. Which ions rush into the axon during depolarisation?

Exam practice Exam set

National-exam style questions on this simulation (17 marks). Try each one on paper first, then open the marking scheme.

Sketch and label an action potential, showing the resting potential, threshold, depolarisation, repolarisation and hyperpolarisation, with values. (5 marks)

Marking scheme: Resting at −70 mV (1); threshold about −55 mV (1); rapid rise to about +40 mV labelled depolarisation (1); fall labelled repolarisation (1); dip below −70 mV labelled hyperpolarisation, then return (1).

Explain the role of sodium and potassium ions in an action potential. (4 marks)

Marking scheme: Na⁺ channels open, Na⁺ diffuses in (1), making the inside positive (depolarisation) (1). Na⁺ channels close, K⁺ channels open and K⁺ diffuses out (1), restoring the negative inside (repolarisation) (1).

Explain the importance of the refractory period. (3 marks)

Marking scheme: It makes each impulse separate / discrete (1); it ensures impulses travel in one direction only (1); it limits the maximum frequency of impulses (1).

An impulse takes 2.5 ms to travel 150 mm along an axon. Calculate the speed and suggest whether the axon is myelinated. (3 marks)

Marking scheme: speed = 0.150 m ÷ 0.0025 s (1) = 60 m/s (1); myelinated (fast saltatory conduction) (1).

State two factors other than myelination that affect the speed of a nerve impulse. (2 marks)

Marking scheme: Diameter of the axon: wider is faster (1); temperature: higher is faster, up to a limit (1).

For class and homework

Teacher resources

The worksheet has the steps, an empty results table and all the questions with answer lines. The marking scheme has the expected results and every answer with its marks.

Keep learning

More free practice: Neuron (external website, by PhET Interactive Simulations, University of Colorado Boulder). It opens in a new tab.

This simulation is an original model made for Rwandan learners. Real experiments can give slightly different numbers: a simulation never replaces handling real apparatus when your school has it.